diff --git a/OverheatStalling/progress.md b/OverheatStalling/progress.md
index 16fd359..05ecc58 100644
--- a/OverheatStalling/progress.md
+++ b/OverheatStalling/progress.md
@@ -55,11 +55,29 @@
 
 ---
 
+## 🔧 Adjustment Procedure (2026-03-23)
+
+**Recommended Steps:**
+
+1. **Let saw cool completely** (1+ hour cooling period from previous stall)
+2. **Turn H screw clockwise from 1¾ to 1½ turns** (leaner mixture)
+3. **Start the saw** and let it warm up
+4. **Adjust T screw counter-clockwise** until chain doesn't rotate at idle (likely 2-3 turns)
+5. **Test run for 10+ minutes** to see if stalling is fixed
+6. **If still stalls:**
+   - Fine-tune H in 1/8 turn increments (clockwise = leaner)
+   - Fine-tune L clockwise to 2 turns if needed
+7. **Document final working settings**
+
+**Important:** Make small adjustments (1/8 turn) and let saw stabilize 30 seconds between turns. H screw affects high-speed mixture - give it throttle to feel the difference.
+
+---
+
 ## 📅 Revision History
 
 | Date | Change |
 |------|--------|
-| 2026-03-23 12:59 | Current settings documented - H screw too rich |
+| 2026-03-23 13:29 | Adjustment procedure documented - H to 1½ turns, T to 2-3 turns for test |
 
 ---